挡风玻璃拨水剂
Windshield water-drawing agent
I. Brief introduction of the product:
This additive contains specific ultra-strong active factor and is also excellent used in rainy days. Be able to effectively coagulate the water spot into the water drop and flow away.
II. Application method
A: The rainy environment
1. Spray directly on the windshield surface evenly from the position 15-20 cm away. Avoid contacting the paint part of the vehicle body or other non-glass surface. If not, use the clean dry microfiber cloth for cleaning.
2. Just wait a moment.
3. If more powerful effect is required, the first step can be repeated appropriately.
B: General condition
1. Use is strictly forbidden when the vehicle body is excessively hot or direct exposure to sunshine.
2. Thoroughly clean the glass product surface required to be sprayed in order to achieve a smooth surface. Before spraying this product, the glass surface must be dry.
3. Spray directly on the windshield surface evenly from the position 15-20 cm away. Avoid contacting the paint part of the vehicle body or other non-glass surface If not, use the clean dry microfiber cloth for cleaning.
4. Spray the product on two sides and the rear glass, as well as the rearview mirrors on both sides at the same time.
5. Wait for 5-10 min and then use the clean microfiber cloth to wipe until the surface is smooth.
6. After spraying this product, wait for 5-10 min before using the microfiber cloth to smear it evenly.
III. Physical characteristics
Density:0.83
PH: 6
Antifreeze point: Below -45℃
Flashpoint: <20℃
Appearance: Colorless and transparent
IV. Anti-rust test:
(80℃ 17h) Steel, iron, copper, aluminum and galvanized sheet are all qualified; Copper is 1b.