热塑(注塑)脱模剂
Thermal plastic mold release agent
I. Product introduction:
Mainly apply to mold releaseof EVA, PU, blister, aluminum alloy, plastic, rubber, silicon rubber, hot melt glue product and anti-sticking under adhesive tape slitting and plastic drawing, so as to obtain the engineering effect of smooth appearance and compact and vivid surface.
II. Product characteristics:
1. Extremely low dosage, efficient low-consumption product
2. Good mold release and anti-sticking
3. 130-250℃ high temperature resistance, the agent is compatible with methylbenzene, dimethylbenzene, petroleum ether, diesel, gasoline and kerosene.
4. There are no any hazardous substances generated in the whole production and use process, it is a good environmental-friendly product.
III. Instruction:
Used for EVA, PU, plastic products, blister, plastic drawing, silica gel mold release and anti-sticking, and also directly used and diluted 1-3 times
Used for hot melt glue anti-sticking, diluted 5-10 times. Used for adhesive tape slitting, diluted 1-3 times. Used for aluminum alloy mold release, diluted 10-20 times.
IV. Method of use:
1. Clean molds before using
2. Apply a little release agent on the molds with dry and clean cloth, and form thin and even layer.
3. Actual demolding times depend on different molds and technologies.
V. Physical indicators:
Appearance: faint yellow
Density:0.8
PH=5-6
Anti-freezing: lower than -40℃
Flashpoint:<30℃
VI. Use ratio: Direct use