MOF-FSDF全合成切削添加剂
MOF-FSDF Total Synthesis Cutting Additive
I. Product benefits
1. Lubrication: Good cleaning performance, which improves the surface quality of the workpiece, and excellent penetrating performance which can ensure the effective lubrication of the processed part.
2. Rust protection: With good rust protection for steel and nonferrous metals, it can fully satisfy high standards and requirements of rust protection.
3. Strong extreme pressure and anti-wear performance, which can prolong the service life of tools.
4. It adopts a fully synthesized formula without any toxin, odor, and irritant and in conformity with the requirements of environmental protection, and causes no environmental pollution.
II. Product usage
It is mainly applicable to the grilling, cutting, drilling, boring and other machining techniques of various steel and iron metals, and copper, aluminum, and magnesium.
III. MOF-FSDF total synthesis cutting liquid additive (concentrated liquid) test report
Concentrated liquid
| Appearance | Light yellow transparent and homogeneous liquid | ||||
Physical and chemical indicators | PH value | 9-10 | ||||
Specific gravity | 1.04 | |||||
Pour point | -7℃ (freezing point) | |||||
Open flash point | None. | |||||
Kinematic viscosity | 5.7024mm2/s(40℃) | |||||
Test of storage stability | Test condition | Test results | ||||
At constant 70℃ for 5 h. | No delamination and precipitation. | |||||
At constant -12℃ for 24 h | No delamination and precipitation. | |||||
4000 rpm 30 mins | No delamination and precipitation. | |||||
Dilution solution
(8% concentrated liquid Add distilled water) | Appearance | Colorless clear liquid | ||||
PH value | 9-10 | |||||
Test of defoaming performance | Test condition | Test results | ||||
Place 70 ml of the diluent fluid in a 100 ml measuring cylinder, shake the cylinder up and down at a frequency of 100-120 times/min, and let it stand at room temperature for 10 mins. | Qualified time of defoaming. <10min | |||||
Test of causticity (fully immersed) | Test condition | Test results | ||||
Red copper | At constant 55±2℃ for 8 h. | Qualified | ||||
LY12 aluminum | At constant 55±2℃ for 8 h. | Qualified | ||||
Grade 1 grey cast iron | At constant 55±2℃ for 24 h. | Qualified | ||||
Test of rust protection (Grade 1 grey cast iron) | Test condition | Test results | ||||
Monolithic | At constant 35±2℃ for 24 h. | Qualified | ||||
Lamination | At constant 35±2℃ for 24 h. | Qualified | ||||
Test of bacterial colonies | Dilute the diluent fluid with 0.5% saline solution by 10 times, place 1 ml of the fluid in the sterile petri dish, add in 20 ml of prepared medium, let it culture within the incubation at constant 30 ℃ for 24-48 h, and visually observe if the colony number qualifies. | |||||