引擎机油止漏添加剂
Engine oil stops leaking additive
I. Product function:
1. Assist to prevent the following oil leakage: Oil pan liner, valve cover liner, and some front and rear main oil seal
2. Apply to various engine oils
II. Application method:
1. Start engine to reach normal working temperature, after shutting down the engine, and then pour the stop leaking agent of engine into the engine oil port.
2. Engine runs at idle speed for 5min
3. The first 50km-100km of vehicle driving shall be avoided with violent driving
4. After adding the stop leaking agent of engine, in case of reluctant driving, the engine can run at idle speed for 45min
5. Before adding the stop leaking agent, if the engine oil sludge is too much, it can be used again after cleaning
III. Physical characteristics:
Density:0.87
PH: 6
Antifreeze point:Turbid at -18℃
Pour point:-48℃
Flashpoint:Open at 61℃
Appearance:Transparent light yellow liquid
IV. Use ratio:
250-300ml mixes with 4-5 liters engine oil
V. Demonstration method:
产品名称Product name | 引擎止漏添加剂Engine stop leakingadditive |
Test condition | 80℃22h |
Test results | Steel, iron, copper, aluminum and galvanized sheet are all qualified |
Demonstration of the rubber seal ring activation: The demonstration procedures: Take 50g prepared leakage stopping additive of auto-transmission, heat the additive to about 110 degrees, and stop heating. Then put the rubber ring into the additive after heating, activate for about 10min, take out rubber ring for comparation (compare with the inactivated rubber ring, and can found that the activated rubber ring is softer and elastic;the rubber ring that has not been activated is relatively hard, without elasticity). Remarks: In order to shorten the demonstration time, soak with the enginestop leakingagent stock solution when demonstration, and use it after diluting with engine oil. |